NivaarExam PrepOfficial exam papers ↗

16-Civ-A2 Elementary Structural Design: May 2015

Nivaar worked solution (AI-drafted; not reviewed by a licensed engineer)

  1. Question 1 A1 — Design of the bolted connection at B
  2. Question 2 A2 — Check of the W460×106 column AB
  3. Question 3 A3 — Moments of resistance of the built-up plate section
  4. Question 4 B1 — Moment and shear resistances of the r.c. culvert section
  5. Question 5 B2 — Design of beam-column AB in the determinate frame
  6. Question 6 B3 — Design of beam BC
  7. Question 7 C1 — Design of the oblique sawn timber purlins

Start with Question 1 →

Paper format. National Examinations, May 2015 — 98-Civ-A2 Elementary Structural Design, 3-hour duration, closed book (textbooks and design handbooks permitted; one approved Casio or Sharp calculator). Seven questions in three parts: Part A (A1–A3, structural steel, CSA S16), Part B (B1–B3, reinforced concrete, CSA A23.3) and Part C (C1, timber, CSA O86). A candidate answers two from Part A, two from Part B and the one question in Part C — five solutions, all of equal value. All seven are solved here so the set works as a complete study resource.

Reference texts. CSA S16, Design of Steel Structures, with the CISC Handbook of Steel Construction; CSA A23.3, Design of Concrete Structures, with the CAC Concrete Design Handbook; CSA O86, Engineering Design in Wood, with the CWC Wood Design Manual; National Building Code of Canada (load combinations); Kulak & Grondin, Limit States Design in Structural Steel; MacGregor & Bartlett, Reinforced Concrete: Mechanics and Design.

Check — load factors. Note 6 on page 1 states “All loads shown are unfactored”, but the paper never splits the figure loads into dead and live components. Every applied figure load in Parts A and B is therefore treated as live load and factored by 1.5; concrete self-weight, where it is not expressly excluded, would be dead load at 1.25 (NBCC 4.1.3.2, combination 1.25D + 1.5L). Part C names its components, so 1.25D + 1.5L is applied directly there. If an examiner intended a different split, the method below is unchanged — only the numerical factor moves.

Check — figure dimensions. All four figures are hand sketches on page 3; every dimension below was read from the printed figures. Figure A2 reads 80 – 300 – 80 across the bottom plate (overall 460 mm wide) with the 300 mm dimension spanning the two web centrelines, and 250 mm overall depth. Figure B1 reads 3.0 m top, 2.5 m bottom, 2.0 m deep, walls “300 constant” and cover “70 typical”. Figure B2 reads 5 m + 5 m span, 4 m + 4 m column height, roller at A and hinge at D.