Paper format. National Examination, 07-Mec-A4 Design and Manufacture of Machine Elements, May 2013 — 3 hours, open book, any non-communicating calculator permitted. Eight questions on six pages, divided into Part A (manufacturing processes, Q1–Q4) and Part B (machine-element design, Q5–Q8). The rubric asks for three from Part A and two from Part B, five questions constituting a complete paper, all of equal value (20 % each). All eight questions are solved here, because this document is a study resource rather than an examination script.
Reference texts.
- Kalpakjian & Schmid, Manufacturing Engineering and Technology, 7th ed. — grinding (Ch. 26), sheet-metal forming and the forming-limit diagram (Ch. 16), sand casting and casting defects (Ch. 11–12).
- Budynas & Nisbett, Shigley's Mechanical Engineering Design, 10th/11th ed. — combined stresses and static failure theories (Ch. 3, 5), fatigue (Ch. 6), shaft design (Ch. 7), bolted joints in shear (Ch. 8), welded joints (Ch. 9).
- Hibbeler, Mechanics of Materials, 10th ed. — stress transformation and combined loading.
- ASM Handbook Vol. 15, Casting — gas, penetration and mould-wall-movement defects in no-bake sand systems.
Check: Part B is figure-driven. Every dimension used below was read from the printed figures (Fig. S4–S7). Where the drawing dimensions a distance from a face rather than from a bolt centre (Q7), the reading is stated explicitly in Given so a grader can substitute a different interpretation without redoing the method.
