NivaarExam PrepOfficial exam papers ↗

16-Civ-B3 Geotechnical Design: December 2013

Nivaar worked solution (AI-drafted; not reviewed by a licensed engineer)

  1. Question 1 Selecting in-situ equipment for bearing capacity and settlement in sand
  2. Question 2 Choice of method for the short-term capacity of a pile in soft clay
  3. Question 3 Explaining active failure behind a yielding wall with Mohr circles
  4. Question 4 Why long-term slope stability is checked with a smaller margin
  5. Question 5 Expansive clay backfill: problems and design measures
  6. Question 6 Allowable bearing pressure of a 1 m square footing in sand
  7. Question 7 Ultimate capacity of a driven concrete pile by two methods
  8. Question 8 Overturning and sliding stability of a cantilever retaining wall
  9. Question 9 Undrained stability of a canal bank cut in saturated clay

Start with Question 1 →

Paper format. National Examinations, December 2013 — 98-Civ-B3 Geotechnical Design. Three hours, open book, any non-communicating calculator. Section A holds five 7-mark discussion questions (answer any four); Section B holds four 24-mark design questions (answer any three), so the examinable total is 4 × 7 + 3 × 24 = 100 marks. Every one of the nine questions is answered here, because the set is a study resource rather than a sitting.

Reference texts. B. M. Das, Principles of Foundation Engineering (9th ed.) and Principles of Geotechnical Engineering (9th ed.); Canadian Geotechnical Society, Canadian Foundation Engineering Manual (CFEM, 4th ed.) — the governing Canadian reference for foundation practice; R. F. Craig, Craig's Soil Mechanics (9th ed.); D. P. Coduto, Foundation Design: Principles and Practices (3rd ed.).

Sources of design charts and assumed values (paper Note 6). The paper requires every chart and assumed value to be identified. Bearing-capacity factors are Terzaghi’s (Das, Foundation Engineering, Table 3.1, with Nγ after Kumbhojkar 1993); the pile end-bearing factor Nq* is read from Meyerhof’s chart (Das Fig. 11.14) and cross-checked against Janbu’s closed-form expression; the adhesion factor α is Das Table 11.5 (Terzaghi, Peck & Mesri); the strain-influence distribution is Schmertmann, Hartman & Brown (1978). Assumed values — specific gravity of solids Gs = 2.65 for the Question 8 backfill, base friction δ = ⅔φ′ and base adhesion ca = ⅔c′ (CFEM §24), and a driving-parameter value K = 1.4K0 for a high-displacement driven pile (Das §11.11) — are flagged where they are used.
Check — Question 6 text and figure disagree. The printed text of Question 6 states a 1 m × 1 m square footing with γ = 20 kN/m³ and φ = 36°, while Figure 3 is drawn for a 2.5 m footing with γ = 18 kN/m³ and φ′ = 38°. The question text governs (it is the instruction to the candidate); the figure is used only for the embedment Df = 1.5 m and for the CPT modulus profile, which the text does not restate. The alternative reading is noted at the end of the answer.