NivaarExam PrepOfficial exam papers ↗

16-Civ-B7 Transportation Planning and Engineering: May 2013

Nivaar worked solution (AI-drafted; not reviewed by a licensed engineer)

  1. Question 1 Earthwork Volumes — Reservoir Storage and Embankment Fill
  2. Question 2 Asphalt Mixture Volumetrics
  3. Question 3 Concrete Pavements — Materials, Joints and Curing
  4. Question 4 Sag-Curve Comfort Length and the CBR Test
  5. Question 5 Standard Proctor Compaction and the Zero-Air-Voids Line
  6. Question 6 Crest Vertical Curve — Geometry, Sight Distance and Grade
  7. Question 7 AASHTO-93 Rigid Pavement Thickness Design

Start with Question 1 →

Paper format. 98-Civ-B7 Highway Engineering, National Examinations May 2013 — a three-hour open-book examination; any non-communicating calculator is permitted. The cover page states that a total of five solutions is required, that only the first five as they appear in the answer book will be marked, and that all questions are of equal value. The grading scheme on the last page confirms 20 marks per question: Q1 (a) and (b) 10 marks each; Q2 (a) through (e) 4 marks each; Q3 (a) to (j) 2 marks each; Q4 (a) and (b) 10 marks each; Q5 (a) and (b) 10 marks each; Q6 (a) through (e) 4 marks each; Q7 20 marks. All seven printed questions are worked here, because this set is a study resource rather than a timed attempt; on exam day a candidate submits only the first five, in order. The paper also states that any data not given but required may be assumed, and that assumptions should be recorded with the answer — several questions below need that licence, and each assumption is flagged where it is made.

Reference texts. N.J. Garber and L.A. Hoel, Traffic and Highway Engineering, 5th ed. (geometric design, sight distance, vertical curves, earthwork, pavement design); AASHTO, Guide for Design of Pavement Structures (1993) (rigid and flexible thickness design, reliability, drainage and load-transfer coefficients); Transportation Association of Canada, Geometric Design Guide for Canadian Roads (Canadian design-domain values for sight distance and vertical curvature); Asphalt Institute, Mix Design Methods MS-2, 7th ed. (mixture volumetrics, VMA, VFA, absorbed binder); B.M. Das, Principles of Geotechnical Engineering, 9th ed. (compaction, Proctor testing, zero-air-voids line, CBR); M.S. Mamlouk and J.P. Zaniewski, Materials for Civil and Construction Engineers, 4th ed. (concrete and asphalt materials); A.M. Neville, Properties of Concrete, 5th ed., and CSA A23.1 (air entrainment, curing, joints in concrete pavement).

Check — assumptions carried through this paper. Three items are not supplied by the exam and are assumed under the paper’s own Note 2 (“any data, not given but required, can be assumed”), each stated again at the point of use: (i) Question 5 gives the mass of the Proctor mould but not its volume, so the ASTM D698 / AASHTO T99 standard 101.6 mm mould volume of 944 cm3 is used; (ii) Question 6 does not name a design speed, so the available stopping sight distance is computed from the Canadian/AASHTO eye and object heights of 1.08 m and 0.60 m; (iii) Question 7 lists the modulus of subgrade reaction as “1.0 MPa”, which is dimensionally incomplete — it is read as 1.0 MPa/m and the sensitivity of the answer to that reading is reported with the result.