24-Pet-B4 Well Testing · December 2016
Nivaar worked solution (AI-drafted; not reviewed by a licensed engineer)
EGBC National Exam — Petroleum Engineering, 2016-Dec. 3 hours duration; closed book. This sitting's own cover page reads “98-Pet-B4, Petroleum Geology” and every question is descriptive/interpretive petroleum geology (source rocks, hydrocarbon chemistry, oil sands and tight-oil development, shale gas and coalbed methane, carbonate traps, siliciclastic/deltaic traps) – no well-test pressure-transient content anywhere. Five (5) of the paper's six 20-mark sections are marked (NOTES item 5); all six are solved in full below so this set also serves as a complete study reference. This sitting's Section 6 is a Siliciclastic Traps section (wave-dominated delta, grain-size–permeability–porosity relations, sandstone diagenesis). The paper is entirely qualitative (draw/describe/define/list), with no numeric given data anywhere.
Reference texts: Selley, R.C. & Sonnenberg, S., Elements of Petroleum Geology, 3rd ed., Academic Press (source rocks, migration, traps, carbonate systems, oil sands); Tissot, B.P. & Welte, D.H., Petroleum Formation and Occurrence, 2nd ed., Springer (kerogen typing, maceral groups, catagenesis); Boggs, S. Jr., Petrology of Sedimentary Rocks, 2nd ed., Cambridge (source-rock, deltaic and carbonate lithofacies; sandstone diagenesis); James, N.P. & Jones, B., Origin of Carbonate Sedimentary Rocks, Wiley-Blackwell (carbonate platform/ramp/sabkha facies models); Butler, R.M., Thermal Recovery of Oil and Gas, Prentice Hall, 1991 (SAGD, CSS, oil sands thermal recovery); Green, D.W. & Willhite, G.P., Enhanced Oil Recovery, SPE Textbook Series Vol. 6 (thermal EOR mechanisms); Law, B.E. & Curtis, J.B., “Introduction to Unconventional Petroleum Systems,” AAPG Bulletin 86, 2002 (shale gas, tight gas, coalbed methane); Lee, W.J. & Wattenbarger, R.A., Gas Reservoir Engineering, SPE Textbook Vol. 5 (unconventional gas reservoir characterization).
Question text not reproduced: the examination questions are © Engineers and Geoscientists BC. Open the official past paper (linked at the top of this page) to read the question, then follow the worked solution below.
Gas in a coal bed is stored predominantly (typically 85–95% of total gas-in-place) as an adsorbed, near-monolayer film on the enormous internal surface area of the coal matrix's micropore network (coal can have internal surface areas of several hundred m²/g, orders of magnitude greater than a conventional reservoir rock), described quantitatively by the Langmuir isotherm relating adsorbed gas content to pressure. The remaining minor fraction exists as free gas within the cleat (fracture) system and as gas dissolved in the cleat water. This is fundamentally different from a conventional reservoir, where essentially all gas is free gas occupying primary/secondary pore space.
